Mast Drop using the LSC Derrick
Availability
A derrick is provided to enable members to raise/drop masts in sympathy with the lifts.
The Derrick will be positioned inside the lagoon west wall about a month before the lift date(s).
It will similarly be recovered to the pontoon after the lift dates.
We cannot wait until all masts are raised. beyond this lifts can be arranged at local boatyards.
There is a tide gauge adjacent to the derrick that shows the depth at the derrick (NOT the state of tide).
Please use it with consideration for other members, It should take about 30 mins. Be aware that deeper boats have limited access to high tides to access it and working members may only have weekends. also be aware that others may be waiting for access so please confer.
Use the derrick only to step/unstep the mast and then leave to to further work (eg fitting boom/sails, rig tuning elsewhere.
There may well be some assisted sessions where you can book a 30 minute slot. check the whatsapp groups. Priority will be given to those who have booked on these days, typically weekends. Once you know how to do it, please volunteer to help these sessions next time.
( it should take no more than 30 mins if the preparation is done. You will be turned away if it isn't so as not to compromise the next boat.)
It’s simpler than this detailed method suggests, especially with familiar helpers
It just needs vigilance, forethought and at least 2 helpers.
It helps to team up with another boat or two.
All but shoal draft boats will need to use a spring high to access it.
Please advise the club office that you have used it. There is a nominal charge.
Tools for mast drop:
Spring tide if necessary
Supports for the dropped mast ( eg crutch or x frame aft and a short cross beam for the pulpit)
Have a line on the pulpit beam, it’s easy to knock it overboard.
Pliers to remove split pins or lock wire.
Spanners to unscrew bottlescrews
Hammer and punch ( eg screwdriver) to knock out mast pin.
Mole wrench
Spares for all essential tools in case you drop one overboard.
Method
Before the drop day..
Sails off.
Boom off.
Wiring disconnected.
On the drop day…
Leave a crew on the derrick to take your lines.
Fenders out both sides.
Lines ready both sides
Leave the tender on the mooring ( see below for why)
Go to derrick before HW. Don’t push your luck on the ebb or you’ll be there for hours.
You may well become part of a raft, so it’s best to go bows east (stbd to derrick) to leave easier.
Turn round on the derrick/raft if necessary.
Don’t make the raft more than 3 boats wide. Go back out and wait if need be or tie to a boat in the lagoon.
Don’t gomuch beyond a boat length north of the derrick, or you will run aground.
pass the derrick and turn 180 to approach and moor.
If in a raft, prep yourself, learn, and be useful to other boats.
When you are alongside the derrick:
Put your own mast foot immediately opposite derrick tower by adjusting boat springs.
Swing derrick boom a few inches ahead of mast and on the centreline using derrick boom lines.
Remove locking from all stays. Should be 2 on each bottle screw, pins, wires or locknuts.
Keep some of the pins so you can buy replacements
Remove pin from mast foot if possible ( if there is one and it can be moved, if not yet do as early as you can)
This is to avoid the mast levering the pin as its removal progresses.
Slacken cap shrouds but leave them attached.
Slacken and completely release lower stays. ( unscrew the bottle screw to release,, park the bottle on the boat thread , not on the rigging)
Don’t be surprised if you have to turn the bottle screw clockwise to loosen. Perversely it’s the norm!
Mast is now still held sideways by cap shrouds, fwd/aft by fore/backstays
Wrap lifting strop around mast and all the (hanging loose) lower stays, add a downhaul( in case it gets stuck and you have to abort!)
Keep the lifting strop fwd of the mast.
Avoid the risk of the strop jambing at the crosstrees.
Don’t drop any part of it.
Leave the shackles attached to the strop. Hook the strop shackles to the derrick hook
Lat the boom out so it is centred over the mast foot
Winch strop up to crosstrees, take a little weight on it.
Position the supports for descent.
Mast is now supported by the derrick,
Now to disconnect from the boat!
Remove forestay pin from stem head by releasing tension on backstay. Use a winch on a halyard if necessary.
Prevent forestay from damaging foredeck ( 3RD man holds it or tie a loose loop to pulpit)
Remove the mast pin if not already done.
1st man holds foot of mast while 2nd man removes cap shrouds, ( leeward first if there’s any crosswind)
3rd man is still holding forestay
2nd man moves to derrick and winches mast off the foot so it hangs from the derrick
3rd man is still holding forestay, 1st man is holding mast.
Mast should lift off foot . mast may be top heavy, so 1st man must hang on to it!!
Keep a watchful eye aloft for snags eg furling foil snagged over the derrick boom.
1st man walks fwd holding mast while 2nd man winches down.
3rd man guides roller furler over pulpit, keeping an eye aloft so it doesn’t get caught over the derrick boom.
Mast and furler now come together so either 1st or 3rd man holds both.
Mast should be free to descend. Check that it is.
2nd man continues to drop mast until approx horizontal.
Swing mast fwd to access masthead and remove aerial , masthead light, wind transducer etc.
Balance overhangs, guide mast into supports, release and & secure for transit back to mooring.
Remove strop from mast and park it back on the derrick.
Winch the boom back to the derrick and tie the rope restraint tight .
The rope restraint is a defence against the boom falling.
The next arriving yacht doesn’t want the boom in the way.
Vacate the derrick for the next boat.
Leave a crew on the derrick if you can, but picking up a mooring singlehanded with mast on the deck and no tender on the mooring can be difficult, so take a crew if you can.
Tidy up on the mooring, use a line to wrap the stays around the mast & leave the deck as clear as possible.
The boat will be less stable with the mast down and must be securely tied down.
Leave it safe for a storm. don't depend on good weather next day.
Always rig a downhaul even if dropping mast. If it all goes badly you MUST be able to reinstate and retrieve the lift line from the erect mast!!
Dont drop anything overboard. You need it all.
Don't take any of it home so it’s all on board when the mast goes back up!!
Hoisting is same in reverse, but arrive with not much to prepare, just get the mast up safely and leave asap.
Lock the bottlescrews on the same day. Do not depend on good weather to come back. Rigs have been lost this way
Andrew Cherowbrier, LSC